This macro will help you build without a shift and click automatically on the PCM (right mouse button), something like an autoclicker, but it works much easier and faster, while in order to activate it follow the following instructions : 1. Download this macro from the site where it is published. 2. Go to Keyran -> Editor -> look for the horizontal menu from below -> on the right in the menu there is a slightly open folder in a horizontal position -> click on it -> look for the downloaded file -> open the file -> then find the vertical menu with 3 arrows that go in a circle, then click on them and select the item with digit 2 (this is required so that when you click on the button, the macro starts itself, but in order for it to turn off, you will need to click on the button again.Or you will choose the mode with digit 1, the principle is about the same, but you only need to pinch the macro to work so that the macro turns off, just release the button) -> If you need to save this macro, then use the menu from above -> in this menu, find some scissors -> to the right of them is a certain file button if it is gray, then it means you have saved otherwise bluish, then click on it. 3. After successfully installing the file into the program, close the Editor -> select and install the macro on the button that is convenient for you when pressed, then click on the program launch button (a triangle in the frame (a certain button under the right ctrl)) After which I wish you successful use!
Download the program (Download) and go to the macro editor
press the button «Open file»
and select the downloaded file
assign a macro to a key and run the program