This macro will help you to put lava / or someone may want to put water under the enemy (or near the enemy). Video review on the macro https://youtu.be/Q0Ap2k74C6o (Access exclusively by link). I advise you to set the macro operation mode «without repetitions». Below is an instruction for those people who do not know how to download macros: 1. Download this macro from the site where it is published. 2. Go to Keyran -> Editor -> look for the horizontal menu from below -> on the right in the menu there is a slightly opened folder in a horizontal position -> click on it -> look for the downloaded file -> open the file -> then find the vertical menu with 3 arrows that go in a circle, then click on them and select the item with the number 2 (this is required so that when you click on the button, the macro will start itself, but in order for it to turn off, you will need to click on the button again. Or choose the mode with the number 1, the principle is about the same, but you only need to pinch the macro to work, so that the macro turns off, just release the button) -> If you need to save this macro, then use the menu from above -> in this menu, find some scissors -> to the right of them is a certain file button if it is gray, then it means you have saved otherwise bluish, then click on it. 3. After successfully installing the file into the program, close the Editor -> select and install the macro on the button that is convenient for you when pressed, then click on the program launch button (a triangle in the frame (a certain button under the right ctrl)) After that, I wish you a successful use! Important note! This macro was used on a computer with a resolution of 1280 x 1024.
Download the program (Download) and go to the macro editor
press the button «Open file»
and select the downloaded file
assign a macro to a key and run the program